学年

教科

質問の種類

数学 大学生・専門学校生・社会人

⑵はなんで階差数列じゃないのか教えてください

基本 例題 50 XPY (=60°)の PX, PY および円 以下、同様にして 円Oの半径 2)円Oの面積 基本 例題 49 図形と漸化式 (1) 領域の個数 00000 2本の直線がある。 次の場合、 平面上に,どの3本の直線も1点を共有しない, n 平面が直線によって分けられる領域の個数をnで表せ。 (1)どの2本の直線も平行でないとき。 (2)n(n≧2) 本の直線の中に, 2本だけ平行なものがあるとき。 指針 (1)場合について,図をかいて考えてみよう。 a2=4(図のD1~D) であるが,ここで直線 l を引くと, l3 は l, l2 と2点で交わり この2つの交点では3個の 線分または半直線に分けられ、領域は3個 (図のDs, De, D) 増加する。 [類 滋賀大]] n =3 1ℓg Ds D₁ D3 De D, D₂ D 143=7 よって a3=az+3 同様に,n番目と(n+1)番目の関係に注目して考える。 解答 n本の直線によって α 個の領域に分けられているとき,(n+1)本目の直線を引く と領域は何個増えるかを考え, 漸化式を作る。 (2)(n-1) 本の直線が (1) の条件を満たすとき, n本目の直線はどれか1本と平行に なるから (n-2) 個の点で交わり (n-1) 個の領域が加わる。 (1) n本の直線で平面が an個の領域に分けられていると する。 (n+1) 本目の直線を引くと,その直線は他のn本の直 線で (n+1) 個の線分または半直線に分けられ,領域は (n+1) 個だけ増加する。ゆえに an+1=an+n+1 また a=2 よって an+1-an=n+1 数列 {an} の階差数列の一般項はn+1であるから, n≧2のとき an=2+2(k+1)=n'tn+2 n-1 k=1 2 これはn=1のときも成り立つ。 ゆえに,求める領域の個数は n2+n+2 (n+1) 番目の直線はn 本の直線のどれとも平行 でないから,交点はn個。 n-1 n-1 ◄Σ (k+1)= Σk+Σ Ck+21 k=1 (1)円O このとき (2)等比数 【CHART (1) 右の図 て Or 答 Or 0 ZOnOn+ よって rnt ゆえに また よって から (2) Sn= 2' (2)平行な直線のうちの1本をℓとすると,lを除く k=1 =(n-1)n+n-1 an-1(1)の結果を利用。 (n-1) 本は (1) の条件を満たすから,この(n-1) 本の 直線で分けられる領域の個数は (1) から 更に、直線 l を引くと, lはこれと平行な1本の直線以 外の直線と (n-2) 個の点で交わり, (n-1) 個の領域が 増える。 よって,求める領域の個数は an-1+(n-1)=(n-1)2+(n-1)+2_ +(n-1)=- n²+n 2 an-1 は (1) の annの 代わりに n-1 とおく。 Ale Sit 50 直線メラ に垂線 皿け同一の点で 更に、

未解決 回答数: 0
数学 大学生・専門学校生・社会人

多様体を構成するために、位相空間に完全アトラスを導入するところで質問です。 完全アトラスを導入するメリットとして、この文章の下線部を「異なる座標系を用いたのに同じ計算ができてしまうという問題が解消される」解釈したのですが、そこがよくわかりません。座標系を変えて計算する... 続きを読む

1 Two n-dimensional coordinate systems & and ŋ in S overlap smoothly provided the functions on¯¹ and ŋo §¯¹ are both smooth. Explicitly, if : U → R" and ŋ: R", then ŋ 1 is defined on the open set ε (ur) → ° (UV) V and carries it to n(u)—while its inverse function § 4-1 runs in the opposite direction (see Figure 1). These functions are then required to be smooth in the usual Euclidean sense defined above. This condition is con- sidered to hold trivially if u and do not meet. Č (UV) R" Ĕ(U) n(UV) R" S n(v) Figure 1. 1. Definition. An atlas A of dimension n on a space S is a collection of n-dimensional coordinate systems in S such that (A1) each point of S is contained in the domain of some coordinate system in, and (A2) any two coordinate systems in ✅ overlap smoothly. An atlas on S makes it possible to do calculus consistently on all of S. But different atlases may produce the same calculus, a technical difficulty eliminated as follows. Call an atlas Con S complete if C contains each co- ordinate system in S that overlaps smoothly with every coordinate system in C. 2. Lemma. Each atlas ✅ on S is contained in a unique complete atlas. Proof. If has dimension n, let A' be the set of all n-dimensional coordinate systems in S that overlap smoothly with every one contained in A. (a) A' is an atlas (of the same dimension as ✅).

未解決 回答数: 0
1/22