学年

質問の種類

生物 大学生・専門学校生・社会人

至急お願いいたします🚨 生物の質問です。 ミトコンドリアの経路についての説明だと思うのですが、電子オーバーフローモデルと電子分布モデルの違いを教えていただきたいです。 また、どういう仕組みなのか、何故このように電子が流れるのかも教えていただきたいです。 UQ poolはユ... 続きを読む

(A) Electron overflow model (considered out-of-date) Alt UQ pool Alternative oxidase inactive. Alt No alternative pathway activity Cytochrome pathway unsaturated Cyt (B) Electron distribution model (reflects current thinking) UQ pool Cyt Alternative pathway active Cytochrome pathway saturated Alt Alternative oxidase active Alt UQ pool Cyt Cyt Figure 14.33 Two models for regulation of electron flow through the alternative oxidase. (A) In the electron overflow model, no appreciable electron transfer through the alternative pathway takes place until electron flow through the cytochrome pathway is at or near satu- ration. This could result from the effects of respirato- ry control, if the rate of mitochondrial ATP produc- tion exceeds its rate of utilization in the cytosol, or from some externally imposed stress, such as low temperature. Under such circumstances, the UQ pool becomes sufficiently reduced to allow electrons to flow through the alternative oxidase, the latter re- quiring that the UQ pool be 40% to 60% reduced to attain significant activity. (B) In the electron distribu- tion model, the alternative and cytochrome path- ways both show significant activity at low levels of UQ pool reduction, and electrons are distributed be- tween the two pathways on the basis of the relative activities of each pathway. The activity of the alter- native oxidase under these circumstances is thought to be regulated by the action of a-keto acids and by reduction/oxidation of the intermolecular disulfide bond, as well as by additional regulatory mecha- nisms not yet characterized.

回答募集中 回答数: 0
英語 高校生

下から5行目のit would~の文構造がわからないです。back upはどのような働きをしているのでしょうか。 教えて頂けるとありがたいです。

A Makeover for Hoover Dam Hydropower has attracted increasing attention in recent years as a renewable type of clean energy. As long as a suitable water source is available, hydropower facilities are usually good investments, producing energy in a manner that generates far less air pollution and CO2 emissions than fossil fuels do. The most common way to generate hydropower is to trap water at a high elevation behind a dam so it can be released and used to spin turbines below, which, in turn, power electricity-producing generators. However, hydropower has its drawbacks. Droughts and increased water consumption have reduced the flow of many rivers. As rivers become shallower, the necessary volume of water for electricity difficult to maintain, and power supply and generation is dependability are negatively impacted. more Variability in water levels has particularly affected Hoover Dam, a mega-scale hydropower facility in the US state of Nevada. Built in the 1930s at enormous expense to control the frequently flooding Colorado River and maintain a water supply for farmland irrigation, the dam's hydropower capabilities were seen as a way to recover some of the costs of its construction over the long term. The dam's electricity-generating capacity, however, was challenged from the start by seasonal variability in water flow, and in recent years has been greatly reduced by droughts. Combining hydropower with other alternative energy sources, though, may offer a solution. Solar and wind plants can produce enormous amounts of electricity, but one serious downside is that the energy they produce is not available when there is little sun or wind. While conventional batteries can help with this issue, storing such tremendous volumes of electricity has long been a challenge. A recently proposed system for Hoover Dam could provide an answer, though. The plan suggests building a new pumping station that would be powered by both wind and solar. It would push water from the river back up to Hoover Dam, refilling the lake behind it. The water could be released anytime to power the dam's generators in order to reliably meet demand for electricity. Kelly Sanders, an engineering professor at the University of Southern California, is enthusiastic about the storage plan, saying, "We by the p replace fo solat als are st ons to the What is 1 Inst inves 2 WE dams 3 A neg sys 1 en

解決済み 回答数: 1
英語 高校生

【至急】この文章の題名として最も適切なものは何かという問いです。私は、②だと思ったのですが、解答は①です。 よろしくお願い致します。

次の英文を読んで、 問 1 ~ 問8に答えなさい。 (配点50点) Inspired by fierce family battles for the last remaining piece of cake, a team of three high schoolers in southwestern Japan's Oita *Prefecture have invented a device that cuts round cake and pizza evenly, no matter how many pieces are sliced, and their creation won the top prize in the prefecture's invention contest in 2021. The three students are members of the industrial technology club at Oita Prefectural Kunisaki High School. Their clever invention to solve a daily life problem with a flexible *2mindset won the governor's award in the competition and is gathering attention. Twelve students in the electronics department of the school ( 1 ) to the industrial technology club, which has continued to submit works to the invention contest for about 40 years. Five of their creations won prizes in the high school division of the 2021 edition of the competition that was launched in 1941. The top prize-winning device, whose name translates to "Let's kindly divide it up," was invented by second-year students Wataru Onoda, 16, Rinto Kimura, 17, and third-year student Mitsumi Zaizen, 18. It was inspired by bbattles for birthday cake in Onoda’s family. He needed to defeat his rival two sisters in games of rock-paper-scissors to get the last remaining piece because the cake was always cut into eight pieces despite his family having seven members. Based on Onoda's idea to equally divide a cake into seven pieces, Kimura created a drawing and computer program to precisely make parts for the device. While Zaizen could not be involved in the actual production due to preparations for her university entrance she created a video for the presentation, using her experience of winning a prize in the competition for two years in a row. exams, (2 ) a two-month trial and error process, the device was completed. When a cake or pizza is placed on a turntable made with a laser beam machine, it can be cut evenly into

未解決 回答数: 1